(813) 322-5002 Serving all of Pasco County Licensed & Insured · FL CFC1431903

Guide

Hydro Jetting vs Snaking a Drain

A cable and a jetter will both get a stopped drain running. They do not leave the pipe in the same condition. Here is what each one actually does, when each is the right tool, and why a camera should decide which one goes down your line.

Drain cleaningHydro jettingCamera inspection

What a cable machine does

A cable machine, or drain snake, feeds a spinning steel coil down the line with a cutting head on the end. When the head reaches the blockage it bores through it, and the water standing behind the plug drains away.

That is fast, and on the right clog it is the whole job. A hair plug in a tub drain, a wad of paper in a toilet line, a single grease plug in a kitchen arm. Something went down that should not have, the cable takes it out, and the line is fine.

What the cable cannot do is clean the wall. The head is narrower than the pipe. It cuts a hole through the middle of whatever is in there and leaves the rest. If the plug was sitting on a coating of grease or scale, the coating is still there when the cable comes out.

A cable also puts no pressure into the pipe. On a line that is old, fragile or already damaged, that is the reason to use one.

What hydro jetting does

A jetter pushes water at high pressure through a hose with a nozzle on the end. Most of the jets point backward and out to the sides. They pull the hose down the line and hit the pipe wall all the way around as it goes.

Instead of boring a hole, it scours. Grease that has set on the wall like candle wax comes off. Scale on older pipe comes off. Fine root hair that has worked in through a joint gets cut back to the wall. Everything it removes is flushed down the line ahead of it.

When it is done, the pipe is close to its full width again. That is the difference people notice months later. A cabled line has a hole through the buildup. A jetted line has had the buildup taken out.

Jetting takes longer to set up and it needs access, usually a cleanout on the main line. For a single hair plug in a bathroom sink it is more tool than the job needs.

Why a line that keeps clogging usually needs jetting

If a drain blocks, gets cabled, and blocks again a few months later in the same place, the cable did its job. It opened the line. What caused the blockage is still on the pipe wall.

Grease on a kitchen line is the common example. Each cabling leaves a fresh hole through the middle, and the coating keeps building around that hole until food catches and stops it again. Cabling it again restarts the clock. Jetting takes the coating off.

Roots are the other. A cable with a root cutter clears the mat but leaves the fine hair roots in the joint, and they fill the pipe again on roughly the same schedule. Jetting cuts them back closer to the wall. Neither one closes the open joint the roots came in through. That is a repair, not a cleaning.

If you are calling about the same line for the third time, ask for it to be jetted or looked at with a camera, not cabled again.

A cable opens the line. Jetting cleans the pipe. A drain that keeps coming back usually needs the second one.

When jetting is a bad idea

Water at high pressure is hard on pipe that is already weak. Old clay sewer pipe with cracked or offset joints can lose pieces when it is jetted, and a broken piece of clay in the line is a worse blockage than the one you started with.

Old cast iron is the other one. Cast iron drain pipe corrodes from the inside, and in older Florida houses the bottom of the pipe is often where it wears thin first. Jetting a pipe like that can open a hole that was nearly there already.

A line with a known crack, a break or a separated joint should not be jetted until that section is repaired. Water under pressure goes out through the crack and into the soil around the pipe. On a slab house, that soil is what is holding the floor up.

On any of these, a cable is the safer way to get water moving. It does not fix the pipe, but it does not make it worse while the repair is planned.

Let a camera decide, not a guess

You cannot tell from inside the house what the pipe looks like. A drain that clogs every few months could be grease on sound PVC, which jets clean. It could be roots through a cracked clay joint, which a jetter may make worse. The symptom is the same.

A camera on a push cable goes down the line and shows the wall, the joints, any roots, sags or breaks, and what the pipe is made of. It cannot see through standing water, so a stopped line usually gets opened with a cable first and looked at second.

What it shows decides the next step. Sound pipe with buildup gets jetted. Fragile or damaged pipe gets cabled to keep it running, and the damaged section gets repaired. You get to see the same picture we do.

We do not know what is in your line until we have looked, and we will not name a number for the work before we have. Pipe Perfect LLC is a Florida Certified Plumbing Contractor, license CFC1431903.

Straight answers

Common questions

Is hydro jetting better than snaking a drain?

Neither is better on every line. A cable is the right tool for a single plug of hair, paper or grease, and for pipe too fragile to take pressure. Jetting is the right tool when buildup on the pipe wall keeps causing the clog, because it takes the buildup off instead of boring through it.

Can hydro jetting damage my pipes?

On sound pipe, no. On old clay with cracked joints, cast iron that has worn thin, or any line with a known break, it can. That is why a line with a history should be looked at with a camera before anyone jets it.

How long will a jetted line stay clear?

That depends on what caused the buildup and whether it keeps going down the drain. Grease poured down the sink after the line is jetted starts a new coating. Roots grow back through an open joint no matter what cleaned them out. We cannot give you a timeframe for your line without seeing it.

Do I need a camera inspection before jetting?

For a first clog in a sink or tub, usually not. For a main line that has blocked more than once, an older house with clay or cast iron drains, or a line someone has already told you is cracked, yes. The camera is what tells us whether jetting will clean the pipe or damage it.

Where to go next

What we actually do

01

Drain Cleaning

Slow or backed-up sinks, tubs and floor drains, root intrusion, grease buildup, and recurring clogs that keep coming back.

View
02

Sewer Line Repair & Replacement

Sewage backups, gurgling drains, slow-draining fixtures throughout the house, tree root intrusion, and collapsed or offset sewer pipe.

View
03

Emergency Plumbing

Burst or frozen pipe, active flooding, sewage backup, no water at all, and any plumbing failure that cannot wait.

View